AVVOLGICAVO
[raw]
Secondo Normativa gli avvolgicavi per cantiere industriali devono avere le seguenti caratteristiche:
• Incorporare un protettore termico o di corrente che protegga il cavo da surriscaldamenti dannosi, sia con cavo avvolto che disteso
• Il cavo deve essere di tipo H07RN-F con sezione minima di 2,5 mm2 per avvolgicavo da 16A
• Riportare norme e marchio del costruttore, la tensione nominale e le massime potenze prelevabili a cavo avvolto e disteso.
• Costruiti in riferimento alla norma IEC 61316
• Adatti per utilizzo interno ed esterno, anche dove sussistano condizioni ambientali particolarmente gravose, come per esempio cantieri di costruzione e/o demolizione
• Costruiti con materiali termoplastici che superano le prove di resistenza agli urti ed alle escursioni termiche
• Cavo flessibili <HAR> omologato in gomma antiusura (neoprene) tipo H07RN-F
• Spina e prese CEE costruite in conformità alle norme EN 60309-1/2 – grado di protezione IP 67
• Caratteristiche tecniche indelebili riportate sull’etichetta dell’articolo
• Disgiuntore Termico presente su tutti gli articoli che provvede a staccare automaticamente la corrente dal blocco prese in caso di surriscaldamento dia del cavo avvolto che disteso; il ripristino manuale avviene mediante pressione del pulsante rosso dopo che la temperatura si sarà riportata a livelli normali
• Targa identificativa delle informazioni tecniche protetta da vetrino
The standard requires that industrial job site cable winders have the following characteristics:
• Incorporate a thermal or current circuit breaker that protects the cable from overheating damage with the cable both wound and unwound
• The cable must be type H07RN-F with minimum section of 2.5 mm² for 16A cable winder
• Bear the manufacturer’s name and trademark, rated voltage and the maximum power that can be taken with cable wound and unwound.
• Constructed conforming to the IEC 61316 standard
• Suitable for interior and exterior use, even in particularly severe environmental conditions, such as construction or demolition sites
• Constructed with thermoplastic materials that pass shock-resistance and temperature range tests
• Type-approved flexible cable
• EEC plug and sockets constructed in conformity with standards EN 60309-1/2 – protection grade IP 67
• Indelible technical characteristics shown on the article’s label
• Thermal cut-out on all articles that automatically disconnects the current from the socket plot if the wound or unwound cable overheats; it is manually reset by pressing the red button after the temperature has returned to normal
• Identification plate for technical information protected by a slide
[/raw]